I'm kind of new here so please bare with me as I'm trying to use a dual camera setup using the AI178MM but my software (HP3D scan) can only see one. It can see other cameras but the DS driver only shows one. If i were to run 2 different camera/driver it will show as they have a different slots.
If I unplug the active camera it will switch over to the other one as it seems to put priority to the USB id.
Images shows only one driver installed as it's the only one i'm using, installing other drivers will display them even if it's not attached
HP 3d.jpg [ 209.54 KiB | Viewed 358 times ]