Solving one problem leads to another. Solved my OAG back focus problem just to find a new problem. I am trying to connect my Lodestar using the USB hub on my ASI1600 and it works fine when I start PHD2, but when I start SharpCan PHD2 disconnects the camera. If I use a separate USB cable both software stayed connected. I also run my ZWO filter wheel from the same hub, but removing this USB cable has no bearing on the problem. I am using a Deltaco active USB3 15 m extension cable with power supply. I have tried adjusting USB speed but no dice. Is this something anyone else has experienced and does anyone have a solution or suggestions?
Measure cable to be just a little over 10m, yes 12v power in use. Beginning to think the cable is not a superspeed, does it have to be superspeed. Someone said the Lodestar need a lot of power, do you know if that is true and could that be the problem?
Users browsing this forum: No registered users and 3 guests
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum